top of page

Hyundai Santa Fe (2017–2018) Standard Hitch Installation

2017–2018 Hyundai Santa Fe trailer wiring installation

Vehicle Coverage: 2017–2018 Hyundai Santa Fe (3.3L V6 models)

Vehicle-specific hitch

Receiver: 2-inch Class 3

Maximum Towing Capacity: 6,000 lbs

Maximum Tongue Weight: 900 lbs

Installation Time: Typically up to 30 minutes

The 2017–2018 V6 Santa Fe receiver uses both factory weldnuts and through-frame carriage bolts. No drilling is required, but the center bumper fascia panel must be lowered and the hitch side plates aligned precisely with two different sets of mounting hardware.

1. Lowering the Center Fascia Panel

The center section beneath the bumper is released to expose the rear mounting area. The spare tire can also be lowered temporarily when additional room is needed to position the receiver.

2. Checking the Bumper Locator Pins

The bumper locator pins are inspected where they approach the hitch side plates. If they interfere with receiver placement, only the necessary portion is bent or trimmed so the hitch can sit squarely against the frame.

3. Starting the Factory-Weldnut Hardware

The receiver is raised to the existing frame weldnuts and four M10 bolts with conical-toothed washers are started by hand. They remain loose while the side-plate holes are aligned.

4. Installing the Through-Frame Hardware

Four half-inch carriage bolts are placed through the side plates and frame rails, then secured with flange nuts. This second set of fasteners ties the receiver into the sides of the rails rather than relying only on the lower weldnuts.

5. Aligning and Tightening Both Hardware Sets

With all eight fasteners started, the receiver is centered below the bumper and both side plates are checked for full contact. The M10 and half-inch hardware are then tightened to their respective specifications.

6. Restoring the Fascia and Spare Tire

The center fascia panel and spare tire are returned to their original positions. Final inspection confirms bumper-panel fit, spare-tire clearance, centered receiver alignment, and usable hitch-pin access.

Curt Champion Logo
Preferred Stealth Hitch Dealer Logo
2024 Best of the Upstate Nominee_edited.

As Seen On

Fox Carolina News
Image 8-9-24 at 5_edited_edited

Serving Upstate South Carolina:

Anderson • Boiling Springs • Clemson • Easley  • Fountain Inn • Gaffney • Greenville • Greenwood • Greer • Laurens • Mauldin • Simpsonville • Spartanburg • Taylors • Travelers Rest 

Serving Western North Carolina:

Arden • Asheville • Black Mountain • Brevard • Candler • Hendersonville • Waynesville • Weaverville • Woodfin

bottom of page