
Professional Installation
Convenient Service
Trailer Hitches
Bike Racks
Running Boards
Roof Rails
Hyundai Santa Fe (2021–2025) Hitch Installation

Vehicle Coverage: 2021–2025 Hyundai Santa Fe
Vehicle-specific hitch
Receiver: 2-inch Class 3
Maximum Towing Capacity: 4,000 lbs
Maximum Tongue Weight: 600 lbs
Installation Time: Typically up to 1 hour
The 2021–2025 Santa Fe receiver mounts to six existing weldnuts and does not require drilling. The spare tire, exhaust, and frame-rail plugs must be moved or removed before the hitch can be positioned tightly against the underside of the rails.
1. Clearing the Spare-Tire Area
The spare tire is lowered when equipped so the receiver can be raised without trapping the tire cable or working around the stored tire.
2. Supporting and Lowering the Exhaust
The rear exhaust is supported before its isolators are released. Lowering it creates a direct path to the mounting points while protecting the forward exhaust connections from excessive movement.
3. Removing the Frame-Rail Plugs
One rubber plug is removed from each frame rail to expose the required attachment area. The six factory weldnuts are inspected and cleaned so the mounting bolts can be started freely by hand.
4. Raising and Aligning the Receiver
The hitch is positioned above the exhaust and held against both rails. Six M12 bolts with toothed washers are started loosely before the receiver is centered beneath the fascia.
5. Tightening the Six Frame Bolts
The hardware is tightened in sequence to the hitch manufacturer’s specification. The toothed washers are checked for full seating and both side plates are confirmed flat against the frame.
6. Reassembly and Clearance Check
The exhaust and spare tire are restored. Final inspection confirms clearance around the muffler and tire, centered receiver alignment, and access to the hitch-pin and safety-chain areas.