Professional Installation
Convenient Service

Trailer Hitches
Bike Racks
Running Boards
Roof Rails

The 2018–2024 Enclave hitch installs behind the rear fascia and uses the vehicle’s frame mounting points. The bumper cover and impact structure are removed for access, then restored around the centered receiver.

1. Opening the Rear Bodywork

The taillights, lower fasteners, wheel-opening hardware, and sensor connections are released so the painted fascia can be removed without stressing its side retainers.

2. Removing the Impact Structure

The factory bumper beam is unbolted to expose the rear body mounting faces and the frame openings used by the hitch hardware.

3. Preparing the Frame Hardware

Mounting hardware is guided into the enclosed frame sections and held in position without welding or cutting the visible bumper surface.

4. Raising and Centering the Hitch

The receiver is lifted between the exhaust and rear structure, aligned evenly, and tightened in stages so the opening remains centered.

5. Restoring the Bumper System

The impact structure, fascia, sensors, lamps, and lower trim are returned to their original positions around the receiver.

6. Final Clearance Check

Receiver height, bumper clearance, exhaust clearance, and accessory-pin access are inspected before delivery.

Finished Appearance: The hitch cross tube is concealed behind the bumper and the 2-inch receiver exits through the factory lower access area.

The rating stamped on a hitch does not increase the vehicle manufacturer's towing or tongue-weight limit. We verify the intended use before scheduling and the lower applicable limit always controls.