Professional Installation
Convenient Service
Trailer Hitches
Bike Racks
Running Boards
Roof Rails
Chevrolet Equinox (2018–Present Gas Models) Hitch Installation
Vehicle Coverage: 2018–Present Gas Models Chevrolet Equinox; exact trim, body style, and factory tow equipment are verified before scheduling
Receiver: Fixed 2-inch receiver
Hitch Rating: 4,500 lbs towing / 675 lbs tongue weight, subject to the vehicle manufacturer's limits
Installation Time: Approximately 1–1.5 hours
The gas Equinox hitch mounts inside both rear frame rails. Installation requires supporting and lowering the exhaust, opening the frame access points just enough for the structural hardware, and fishwiring three attachment bolts into each side.
1. Removing the Lower Fascia Fasteners
The small lower-fascia screws that block hitch placement are removed and retained for reinstallation.
2. Supporting and Lowering the Exhaust
The muffler is supported before the rear hanger brackets and forward rubber isolator are released, creating working room without loading the exhaust joints.
3. Preparing the Frame Access Openings
The existing access opening in each frame rail is enlarged only enough for the specified carriage-bolt hardware to pass through.
4. Fishwiring Six Structural Mounting Points
Three bolts and spacers are guided through each frame rail and held in position while the receiver is lifted.
5. Raising, Centering, and Torquing the Hitch
The receiver is raised around the exhaust, all six fasteners are started before tightening, and the hitch is centered beneath the bumper before final torque.
6. Restoring the Exhaust and Checking Clearance
The exhaust hangers and fascia screws are reinstalled, then clearance is checked around the muffler, heat shields, fascia, receiver, and safety-chain loops.
Finished Appearance: The main cross tube tucks behind the lower bumper area; the centered 2-inch receiver and safety-chain loops remain visible below the fascia.