Professional Installation
Convenient Service

Trailer Hitches
Bike Racks
Running Boards
Roof Rails

The 2018–2023 Traverse receiver replaces the original rear bumper beam behind the fascia. The bumper cover is removed, the hitch is secured at the factory studs and frame rails, and Chevrolet’s removable center panel preserves access without leaving the cross tube exposed.

1. Releasing the Rear Fascia

Hatch-area covers, lamp fasteners, wheel-liner screws, lower supports, and side retainers are removed methodically before the fascia is pulled from the body.

2. Disconnecting and Protecting Rear Electronics

Parking-sensor or lighting connectors are labeled and disconnected as the bumper cover is supported away from the vehicle.

3. Removing the Factory Bumper Beam

The upper nuts and lower bolts are removed while the beam is supported; the retained factory nuts are reused with the concealed hitch.

4. Installing the Hitch at the Factory Structure

The receiver is placed over the rear-body studs, new lower bolts and washers are installed, and additional frame hardware is fishwired through the hitch access points.

5. Applying Final Torque and Checking Alignment

The receiver is centered to the removable access opening before all frame and rear-body attachments are tightened to specification.

6. Reinstalling the Fascia and Access Panel

Every electrical connector and bumper fastener is restored, panel gaps are checked, and the removable center cover is test-fitted around the receiver opening.

Finished Appearance: The crossmember is fully concealed. The centered receiver is visible only when the factory access panel is removed for use.