Professional Installation
Convenient Service
Trailer Hitches
Bike Racks
Running Boards
Roof Rails
Ford Bronco Sport (2021–Present) Flat-4 Wiring Installation
Vehicle Coverage: 2021–Present Ford Bronco Sport; exact trim and factory tow preparation are verified before scheduling
Output: 4-way flat
Connection Method: Passive, vehicle-appropriate wiring; no programmed active towing module
Finished Connector Location: Mounted outside beside the hitch and protected by a dust cover when not in use.
Installation Time: Approximately 2–3 hours
Connector Location: Mounted outside beside the hitch and protected by a dust cover when not in use.
The Bronco Sport uses a powered vehicle-specific harness connected at both rear lamp circuits. A fused power lead is routed to the battery, while the trailer plug finishes outside at the receiver.
1. Accessing Both Rear Lamp Connections
Required rear trim and lamp access points are opened carefully so the exact-fit connectors can be installed without cutting factory wires.
2. Installing the T-Connectors and Converter
Driver- and passenger-side connectors are seated and the powered converter is secured in a protected location.
3. Routing the Fused Battery Feed
The power lead is supported beneath the vehicle away from exhaust heat, suspension travel, sharp edges, and road contact.
4. Positioning the Exterior Flat-4
The trailer lead is routed to the receiver and secured where it remains accessible without hanging below the hitch.
5. Testing and Reassembly
Running lights, brake lights, both turn signals, and ground integrity are verified before all trim and lamps are restored.
Our Wiring Standard: Lighting outputs, ground integrity, and any added auxiliary or brake-output circuit are tested before the installation is closed.