Professional Installation
Convenient Service

Trailer Hitches
Bike Racks
Running Boards
Roof Rails

The current Ranger receiver mounts between the frame rails at the rear bumper structure. The bumper is clamped and supported before its structural bolts are removed, allowing the hitch to be installed without losing bumper alignment.

1. Inspecting the Rear Bumper Structure

Bumper alignment, wiring, and the frame mounting area are checked before any structural fastener is loosened.

2. Clamping and Supporting the Bumper

Both bumper brackets are held securely so the bumper cannot shift when the shared mounting bolts are removed.

3. Removing the Structural Bolts

The two large fasteners on each frame rail are removed while the supported bumper remains aligned.

4. Raising the Receiver Between the Rails

The hitch is lifted into position and the original structural hardware is started through the hitch and bumper brackets.

5. Applying High-Torque Final Tightening

The shared fasteners are tightened to the manufacturer specification before the supports are removed and alignment is rechecked.

Finished Appearance: The fixed 2-inch receiver is centered below the bumper with the cross tube integrated tightly between the frame rails.