Professional Installation
Convenient Service
Trailer Hitches
Bike Racks
Running Boards
Roof Rails
Nissan Pathfinder (2022–Present) Hitch Installation
Vehicle Coverage: 2022–Present Nissan Pathfinder; exact trim and tow-package fitment are verified before scheduling
Receiver: Fixed 2-inch receiver
Hitch Rating: 6,000 lbs towing / 900 lbs tongue weight, subject to the vehicle manufacturer's limits
Installation Time: Approximately 1.5–2 hours
The current Pathfinder receiver uses six factory frame weldnuts. Installation requires temporarily lowering the spare tire and rear exhaust, plus a small centered trim beneath the bumper for receiver clearance.
1. Lowering the Spare Tire
The spare tire is lowered and set aside to open the center mounting area without damaging the tire or hoist cable.
2. Supporting and Lowering the Rear Exhaust
The exhaust is supported before three rubber hangers are released, creating the room needed to raise the receiver into position.
3. Trimming the Lower Fascia
A measured 4.25-inch by 2.5-inch section is marked at the underside center of the bumper and trimmed cleanly for receiver clearance.
4. Raising and Aligning the Hitch
Two installers lift the receiver to the frame rails and start all six bolts loosely in the existing weldnuts before centering the opening.
5. Applying Final Torque
The mounting bolts are tightened in sequence and torqued to the manufacturer’s specification. No frame drilling or welding is required.
6. Restoring the Exhaust and Spare Tire
All exhaust hangers are reinstalled and the spare is raised with a slight forward bias for receiver clearance, followed by a full fit inspection.
Finished Appearance: The cross tube is concealed behind the bumper, leaving the 2-inch receiver and safety-chain loops visible below the lower fascia. The installed-vehicle photo is shown using Fit so the full rear view remains visible without cropping.