Professional Installation
Convenient Service

Trailer Hitches
Bike Racks
Running Boards
Roof Rails

1. Remove the Exhaust Bezel

Remove the two retaining nuts on both sides of the lower exhaust bezel. Carefully remove the bezel and set it aside for reinstallation.

2. Lower the Muffler

Support the muffler, remove all four hanger rods from their rubber isolators, and gently pull the bumper cover rearward at the exhaust tips to gain clearance.

3. Remove the Foam Pads

Remove the two foam pads from each side of the frame to expose the factory hitch-mounting area and weldnuts.

4. Position and Torque the Hitch

Raise the hitch into position and loosely install four supplied M12 bolts and washers into the factory weldnuts on each side. Align the receiver, then torque all M12 hardware to 86 ft-lbs.

5. Reassemble the Exhaust

Reinstall the muffler hangers, lower exhaust bezel, and retaining nuts. Confirm the exhaust and rear fascia have proper clearance and complete a final hardware inspection.